R&S NGL200 Series User Manual page 52

®
R&S NGL200/NGM200
Figure 6-10: Range/DVM dialog
Note: The "Voltage Autorange" and "Voltage Range" are not available if DVM is
enabled.
4. Activate the "Enable DVM Measurement" menu item.
The R&S NGL/NGM enables the DVM measurement and displays a DVM text in
the channel display area. See
5. To configure the voltage range, set "Enable DVM Measurement" to "OFF".
Select any of the following to configure the voltage and current measurement
range.
●
●
Measurement range
Correct setting of voltage and current range increases the accuracy of the voltage/
current measurements. Measuring outside the range values may result in invalid mea-
surements with OVERLOAD indicator.
See the datasheet for the measurement accuracy according to the measurement range
selected.
Table 6-1: Voltage and current range
Available voltage ranges
Auto
5V
20V
Available current ranges
Auto
10 A
1 A
User Manual 1178.8736.02 ─ 05
"Voltage Autorange" / "Current Autorange": Best display of voltage or current
measurement range
"Voltage Range" / "Current Range": See
To select the voltage or current range, set the auto range to "OFF".
Ranges / Digital Voltmeter (DVM)
Chapter 5.1.2, "Channel Display
Table 6-1.
Instrument selects the best range to display.
Accuracy from 0 V to 5 V.
Accuracy from 0 V to 20.05 V.
Instrument selects the best range to display.
Accuracy from 0 A to 10 A.
Accuracy from 0 A to 1 A.
Instrument Functions
Area", on page 29.
49