R&S NGL200 Series User Manual page 65

®
R&S NGL200/NGM200
6. Select "Digital Output" to configure the trigger-out parameter.
The R&S NGL/NGM displays the "Digital Output" dialog.
Figure 6-21: Digital Out dialog
7. Depending on your requirements, select the digital output accordingly.
The two Digital I/O output pins OUT1 and OUT2 can be set directly by the SCPI
commands. See
See also
8. Select the respective "Digital Output" menu items and set "On" to enable the trig-
ger-out parameters.
9. Select "Back"
10. If "User Button" is set as a trigger-in signal, select "User Button" menu item.
The R&S NGL/NGM displays the "User Button" dialog.
See also
11. Select "User Button Action" and set as "Trigger".
The R&S NGL/NGM generates a trigger-in signal when
12. If "Logging" is set as a trigger-out signal, select "Logging" menu item.
The R&S NGL/NGM displays the "Logging" dialog.
See also
13. Select "Triggered" and set as "On".
The R&S NGL/NGM starts the data logging of the instrument when a trigger is
detected.
14. If "Arbitrary" is set as a trigger-out signal, select "Arbitrary" menu item from the
respective channel menu.
The R&S NGL/NGM displays the "Arbitrary" dialog.
See also
15. Depending on your requirement, select "Start triggered" or "Step triggered" menu
item and set "On".
User Manual 1178.8736.02 ─ 05
DIO:OUTPut[:STATe]
Figure 6-18 for details of the trigger-out parameters.
to go back to "Device" menu.
Chapter 6.8, "User Key",
Chapter 6.10, "Data Logging",
Chapter 6.7.1, "Arbitrary",
on page 139.
on page 67.
user button
on page 69.
on page 63.
Instrument Functions
Trigger / Digital I/O
key is pressed.
62