R&S NGL200 Series User Manual page 82

®
R&S NGL200/NGM200
1. Connect the LAN cable to the LAN connector at the rear panel of the instrument.
2. Select "LAN" to set LAN connection.
The R&S NGL/NGM displays the "Ethernet Settings" dialog.
Note: The "MAC Address" is fixed.
Figure 6-35: Ethernet settings dialog
3. Set the "Dynamic Host Configuration Protocol (DHCP)".
●
●
4. Set the required DHCP mode.
If DHCP mode is set "OFF", the following "Ethernet Settings" are required.
5. Configure the "IP Address", "Subnet Mask" and "Gateway".
The R&S NGL/NGM displays the IP dialog for configuration.
Figure 6-36: IP dialog
6. Set the required IP addresses for "IP Address", "Subnet Mask" and "Gateway"
User Manual 1178.8736.02 ─ 05
"ON": Enables DHCP for automatic network parameter distribution and shows
the values of the IP Address. By default, the instrument is configured to use
dynamic configuration and obtain all address information automatically.
"OFF": If the network does not support dynamic host configuration protocol
(DHCP). The addresses must be set manually.
Instrument Functions
Interfaces
79