R&S NGL200 Series User Manual page 115

®
R&S NGL200/NGM200
Example: Activating the channels
You can activate a selected channel and turn on or off the outputs either individually or
all outputs simultaneously. This example lists all ways how you can activate and query
the outputs.
// ************************************************
// Activate a channel
// ************************************************
INST OUT1
OUTP:SEL 1
// activates the selected channel
OUTP 1
// activates channel 1 and its output
OUTP?
// queries the output state
// response: 1
// ************************************************
// Turn on all selected channels simultaneously
// ************************************************
INST:OUT1
VOLT 12
CURR 0.1
OUTP:SEL 1
INST:OUT2
VOLT 12
CURR 0.2
OUTP:SEL 1
// selects channels 1 and 2
// sets the voltage and current values for both channels
// activates both channels
OUTP:GEN 1
// turns on the output of both channels
OUTPut:GENeral[:STATe]
OUTPut[:STATe]
OUTPut:DELay:DURation
OUTPut:DELay[:STATe]
OUTPut:FTResponse
OUTPut:IMPedance
OUTPut:IMPedance:STATe
OUTPut:MODE
OUTPut:SELect
OUTPut:TRIGgered
OUTPut:TRIGgered[:STATe]
OUTPut:TRIGgered:BEHavior
User Manual 1178.8736.02 ─ 05
................................................................................................113
.............................................................................................................113
............................................................................................... 113
.................................................................................................. 114
..................................................................................................... 114
........................................................................................................114
............................................................................................. 115
.............................................................................................................. 115
............................................................................................................. 116
........................................................................................................116
............................................................................................ 116
......................................................................................... 116
Remote Control Commands
Configuration Commands
112