R&S NGL200 Series User Manual page 119

®
R&S NGL200/NGM200
OUTPut:SELect <state>
OUTPut:SELect?
Sets or queries the output state of selected channel.
Parameters:
<state>
Example:
OUTPut:TRIGgered <arg0>
OUTPut:TRIGgered[:STATe] <arg0>
Enables or disables the triggered event for output.
Setting parameters:
<arg0>
Example:
OUTPut:TRIGgered:BEHavior <arg0>
Sets or queries output behavior when a trigger event occurs.
Setting parameters:
<arg0>
Example:
User Manual 1178.8736.02 ─ 05
OFF | ON | 0 | 1
OFF | 0
Deactivates the selected channel.
ON | 1
Activates the selected channel.
*RST: OFF | 0
See Example "Activating the channels"
1
Trigger is enabled.
0
Trigger is disabled.
OUTP:TRIG 1
When a trigger event occurs, respective channel output is trig-
gered.
See
OUTPut:TRIGgered:BEHavior
ON | OFF | GATed
ON
Output is set on when a trigger event occurs.
OFF
Output is set off when a trigger event occurs.
ON
Output is set gated when a trigger event occurs.
OUTP:TRIG:STAT 1
OUTP:TRIG:BEH ON
Remote Control Commands
Configuration Commands
on page 112
on page 116.
116