Siemens SICAM Q100 Device Manual page 367

Parameter/Indications
Parameter: Source of output 1-N
Indication: Input 1-N
Parameter: Source of output 2-N
Indication: Input 2-N
Parameter: Source of output 3-N
Indication: Input 3-N
Parameter: Source of output 1-P
Indication: Input 1-P
Parameter: Source of output 2-P
Indication: Input 2-P
Parameter: Source of output 3-P
Indication: Input 3-P
Subdevice 2
Server IP address
Server port
Response timeout
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Default Setting
Indication 3 from Remote
Binary inp. 1-N SICAM IO 1
Indication 4 from Remote
Binary inp. 2-N SICAM IO 1
Indication 5 from Remote
Binary inp. 3-N SICAM IO 1
Indication 6 from Remote
Binary inp. 1-P SICAM IO 1
Indication 7 from Remote
Binary inp. 2-P SICAM IO 1
Indication 8 from Remote
Binary inp. 3-P SICAM IO 1
192.168.0.57
51 000
3 (* 10 ms)
Setting Range
Parameter: Source of output
(depending on parameterization):
-none-
Device OK
Battery Failure
Settings Load
Settings Check
Settings Activate
Modbus TCP OK
Ethernet Link Error
Time Synchronization Error
Primary NTP Server Error
Secondary NTP Server Error
Daylight Saving Time
Ethernet Link 2 Error
Default IP Address
Limit Violation x (x = 1 to 16)
Indication 1 from Remote
Indication 2 from Remote
Rotation Voltage Clockwise
Group Indication x (x = 1 to 4)
IEC 61850 Communication OK
SD Card Error
Voltage Event Available
Frequency Event Available
Voltage-Unbalance Event Available
Indication x from Remote (x = 3 to 14)
SICAM Subdevice 1 OK
SICAM Subdevice 2 OK
Binary Input x-N SICAM IO 1 (x = 1 to 3)
Binary Input x-P SICAM IO 1 (x = 1 to 3)
Binary Input x-N SICAM IO 2 (x = 1 to 3)
Binary Input x-P SICAM IO 2 (x = 1 to 3)
Load profile period closed
Load profile synchr. period
Load profile tariff x (x = 1 to 6)
*)
Binary input 1
*)
Binary input 2
Modbus RTU Master OK
New MSV record made
Indication x Slv y (x = 1 to 6; y = 1 to 8)
Indications which are read by Modbus slave
devices are available in the list box if they were
parameterized in Modbus Master Mapping.
*)
Designation can be changed during the pa-
rameterization.
Indication Input:
Indication: any, max. 31 characters
Any
10 000 to 65 535
10 ms to 60 000 ms
0 ms = invalid
15 Operating Parameters
15.6 Administrative
*)
*)
*)
*)
*)
*)
*)
367