Table of Contents
Advertisement
8 Operation at Use of a PC
8.3 Configuration of the Device
To change the Memory management, proceed as follows:
✧
In the navigation window, select the Recording and Reporting menu and click Memory management.
Figure 8-49
✧
Select the respective parameters in the list boxes according to Table 8-17 and enter the desired values in
the associated fields.
✧
After the parameterization click Send.
The parameters are transmitted to the device but not enabled yet (passive set of parameters).
✧
If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
178
Configure Tab, Storage Input/Output Window
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Advertisement
Table of Contents
