Table of Contents
Advertisement
8.3.7.2.1
Parameterizing the Ethernet Communication with Modbus TCP Bus Protocol
General Settings Communication Ethernet
To change the Ethernet communication settings, proceed as follows:
✧
In the navigation window, click the Administrative menu and then the element Communication
Ethernet. Select the bus protocol Modbus TCP.
Figure 8-54
✧
Enter the desired values in the fields and select the parameters in the list boxes and in the option field as
described in Table
NOTE
The enabling of SNMP via option Enable SNMP is only required if you want to save the SICAM Q.mib file and
use it in a MIB browser. See also section Download SNMP Device MIB File.
NOTE
After changing the network settings and subsequent parameter activation the device will reset.
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Configure Tab, Communication Ethernet via Modbus TCP Input/Output Window
8-22.
8 Operation at Use of a PC
8.3 Configuration of the Device
189
Advertisement
Table of Contents
