Siemens SICAM Q100 Device Manual page 334

14 Operational Indications
Indication
Ethernet Link Error
Modbus TCP OK
(Modbus TCP Server)
Modbus RTU Master
OK
IEC 61850 Communi-
cation OK
Settings Load
Settings Check
Settings Activate
Limit Violation x
334
Description
Ethernet connection error
At least one Modbus TCP link has
received Modbus messages.
All configured Modbus slave
devices respond to request tele-
grams.
Communication via protocol
IEC 61850 is correct.
Starting to change the parameters
of the passive set of parameters.
The passive set of parameters is to
be activated; the internal parame-
ter check is running.
The passive set of parameters is
enabled and the device works with
these parameters.
Indication that a parameterized lim-
iting value has been violated
Notes
Indication on: Error
Indication off: Ethernet link recognized
Indication on: At least one Modbus message was re-
ceived during the set monitoring time. The time stamp is
set when the first valid message is received.
Indication off: No Modbus message was received during
the set monitoring time.
See chapter 8.3.7.2
Indication on: If all configured Modbus slave devices
respond successfully to request telegrams.
Indication off: If at least one Modbus slave device does
not respond to a request telegram or if at least one
Modbus slave device responds with a Modbus exception
code (see System Manual Q100; chapter 2.2.2).
See chapter 8.3.7.3
Indication on: At least one message was received during
the set monitoring time. The time stamp is set when the
first valid message is received.
Indication off: No message was received during the set
monitoring time.
See chapter 8.3.7.2
Indication on: Start of changes
Indication off: Changes complete
Indication on: Check started
Indication off: Check complete
Indication on: Activation started
Indication off: Activation complete
Indication on: The limit of the monitored measured value
has been violated or no measured value is parameter-
ized as input of the limiting value.
Indication off: The limit of the monitored measured value
is not violated.
Message invalid: The monitored measured value is
invalid
(e.g. frequency at V < 15 % of V
x = 1 to 16
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
).
rated