Parameterizing the Recorder Parameters
To change the Recorder management, proceed as follows:
✧
In the navigation window, select the Recording and Reporting menu and click Recorder management.
Figure 8-45
✧
Select the desired parameters in the list boxes and option fields as described in Table 8-14.
NOTE
The voltage is recorded in the following connection types:
•
3P4W (3 phases/4 wires): phase-to-phase voltage or phase-to-ground voltage
•
3P3W (3 phases/3 wires): only phase-to-phase voltage
✧
After the parameterization click Send.
The parameters are transmitted to the device but not enabled yet (passive set of parameters).
✧
If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Configure Tab, Recorder Management Input/Output Window
8 Operation at Use of a PC
8.3 Configuration of the Device
171