8 Operation at Use of a PC
8.3 Configuration of the Device
NOTE
If Ethernet communication with Bus protocol IEC 61850 is active (see Chapter 8.3.7.2) and you change
Network type, the device will restart.
✧
After the parameterization click Send.
The parameters are transmitted to the device but not enabled yet (passive set of parameters).
✧
If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
142
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018