8.3.5.2 Tariffs (TOU)
Default Settings and Setting Ranges
Table 8-11
Parameter
Synchronization source
1)
In this case, the protocol Modbus TCP can control tariff 1 to tariff 6. Refer to the System Manual SICAM
Q100, chapter 2.2.7.18 Register 0154: Tariffs (read and write), order number E50417-C1040-C522.
2 )
This synchronization source can only control tariff 1 or tariff 2.
Parameterizing the Tariffs
To change the tariff setting, proceed as follows:
✧
In the navigation window of the Energy management menu click Tariffs (TOU).
Figure 8-42
✧
Select the parameter in the list box according to Table 8-11. After the parameterization click Send.
The parameter is transmitted to the device but not enabled yet (passive parameter set).
✧
If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Tariffs (TOU)
Default Setting
Protocol
Configure Tab, Tariffs (TOU) Input/Output Window
8 Operation at Use of a PC
8.3 Configuration of the Device
Setting Range
1)
Protocol
2)
Binary input 1
2)
Binary input 2
163