Table of Contents
Advertisement
8 Operation at Use of a PC
8.3 Configuration of the Device
Parameterizing a SICAM Subdevice in SICAM Q100
If you want to change the settings of a SICAM subdevice (for example, Subdevice 1: SICAM IO), proceed as
follows:
✧
In the navigation window, click the Administrative menu and the menu item SICAM subdevices.
The SICAM subdevices input/output window opens.
✧
In the Subdevice 1 list box, select the entry SICAM IO.
If you select -none- , no entries exist for the subdevice.
Figure 8-68
✧
In the list boxes, select the respective indication according to Table 8-29. Enter the desired values in the
fields.
NOTE
Indication 1 from remote and Indication 2 from remote are provided for controlling the two binary outputs
of the SICAM Q100. Therefore, Indication 3 from remote is the first assigned indication as Source of output
of the SICAM subdevices.
✧
After the parameterization click Send.
After clicking Send, the parameters are transmitted to the device but not enabled yet (passive set of
parameters).
✧
If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
212
Configure Tab, SICAM Subdevices Input/Output Window
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Advertisement
Table of Contents
