Table of Contents
Advertisement
6.2.2
Assembly
To install the device into a switch panel, proceed as follows:
✧
Push the device in installation position into the cut-out of the switch panel and hold the device tight.
✧
Attach one of the supplied mounting elements each on both sides of the housing.
1 mm (0.04 inch), steel
Figure 6-2
✧
Swing the mounting element (provided with the device) over the rear cone.
✧
Move the mounting element to the position. Use a screw driver (0.6 mm x 4.5 mm) to fix the mounting
elements until the slipping clutch takes effect.
NOTE
The above mounting instructions must be performed correctly to provide sufficient protection against touching
live parts.
UL-Certification Conditions
Field Wires of Control Circuits shall be separated from other circuits with respect to the end-use requirements!
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Mounting plate
Mounting element
Stepwise Installation of the SICAM Q100 into a Switch Panel
6 Getting Started
6.2 Assembly
93
Advertisement
Table of Contents
