8 Operation at Use of a PC
8.3 Configuration of the Device
If you have connected a SICAM I/O Unit as subdevice at the SICAM Q100 and want to change the settings at
the subdevice, proceed as follows:
✧
In the navigation window of the SICAM I/O Unit, click the Administrative menu and then Communication
Ethernet.
Figure 8-69
✧
Enter the values in the fields according to Table 8-31 and select Operating mode I/O Mirror server from
the list box.
✧
After the parameterization click Send.
The parameters are transmitted to the device but not enabled yet (passive set of parameters).
✧
If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
214
Communication Settings in the SICAM I/O Unit if the Device is Connected to a SICAM Q100
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018