Table of Contents
Advertisement
✧
Select the desired parameters in the list boxes and option fields as described in Table 8-5.
NOTE
Select Indication -none- to disable the corresponding LED.
✧
After the parameterization click Send.
The parameters are transmitted to the device but not enabled yet (passive set of parameters).
✧
If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
Behavior of the LEDs
H
Indication
L
LED
ON
Figure 8-33
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Indication
OFF
Behavior of the LEDs
invalid
invalid
flash
flash
8 Operation at Use of a PC
8.3 Configuration of the Device
151
Advertisement
Table of Contents
