Table of Contents
Advertisement
8 Operation at Use of a PC
8.3 Configuration of the Device
NOTE
Which quantities are offered in the Measurement list box depends on the configured network type. The
Network type is specified in the Process connections submenu, AC measurement input/output window, see
chapter 8.3.3.1.1.
✧
After the parameterization click Send.
The parameters are transmitted to the device but not enabled yet (passive set of parameters).
✧
If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
8.3.3.2.2
Group Indications
In the Select automation functions menu, up to 4 Group indications can be parameterized and each of them
can be assigned up to 4 logically linked single-point indications. The single-point indications can be inverted.
Default Settings and Setting of the Group Indications
Table 8-7
Parameter
Source
Source inverted
Logic operation
Group indication name
1)
31 bytes of UTF-8
154
Group Indications
Default Setting
-none-
no
NONE
Group Indication x
(x = 1 to 4)
Setting Range
Acc. to list box
(see chapter 15)
no
yes
NONE
OR
AND
Any
1)
Max. 31 characters
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Advertisement
Table of Contents
