Table of Contents
Advertisement
15.1.4
LEDs
RUN
ERROR
H1
H2
NOTES
Only the indications for the
parameterization of the binary
outputs are displayed which can
be used according to the current
device settings.
Indications which are read by
Modbus slave devices are avail-
able in the list box if they were pa-
rameterized in Modbus Master
Mapping.
Indication inverted
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
LED
Device ready
-none-
-none-
no
Default Setting
Not settable
-none-
Battery Failure
Ethernet Link Error
Time Synchronization Error
Primary NTP Server Error
Secondary NTP Server Error
SD Card Error
-none-
Device OK
Battery Failure
Settings Load
Settings Check
Settings Activate
Modbus TCP OK
Ethernet Link Error
Time Synchronization Error
Primary NTP Server Error
Secondary NTP Server Error
Daylight Saving Time
Ethernet Link 2 Error
Default IP Address
Limit Violation x (x = 1 to 16)
Indication 1 from Remote
Indication 2 from Remote
Rotation Voltage Clockwise
Group Indication x (x = 1 to 4)
IEC 61850 Communication OK
SD Card Error
Voltage Event Available
Frequency Event Available
Voltage-Unbalance Event Available
Indication x from Remote (x = 3 to 14)
SICAM Subdevice 1 OK
SICAM Subdevice 2 OK
Binary Input x-N SICAM IO 1 (x = 1 to 3)
Binary Input x-P SICAM IO 1 (x = 1 to 3)
Binary Input x-N SICAM IO 2 (x = 1 to 3)
Binary Input x-P SICAM IO 2 (x = 1 to 3)
Load profile period closed
Load profile synchr. period
Load profile tariff x (x = 1 to 6)
Binary input 1
Binary input 2
Modbus RTU Master OK
New MSV record made
Indication x Slv y (x = 1 to 6; y = 1 to 8)
*)
no
yes
15 Operating Parameters
15.1 Process Connections
Setting Range
*)
*)
*)
Designation can be changed during
the parameterization.
*)
*)
*)
*)
*)
*)
343
Advertisement
Table of Contents
