Manual Start Of The Boot Loader - Siemens SICAM Q100 Device Manual

12 Failures and LED Indications
12.2 Commissioning during Failures
Starting the User Interface without Uploading a New Firmware
✧
Click Run Application. The following message appears:
Figure 12-2
✧ Wait for at least 20 s and then click the home link.
The user interface opens.
Starting the User Interface with Uploading a New Firmware
✧
Click Browse....
The Choose file dialog opens.
✧
Select the desired firmware package in the directory.
✧ Click Open.
The selected path appears in the Browse... field.
✧ Click upload.
If the firmware upload is successful, the following information is displayed in the Boot Loader window:
Figure 12-3
✧ Wait for at least 30 s and then click the home link.
The user interface opens.
12.2.2

Manual Start of the Boot Loader

If it is necessary to start the Boot Loader manually, proceed as follows:
✧
If the SICAM Q100 is still energized by the supply voltage, switch off the supply voltage.
✧
At the SICAM Q100, press the softkey F4 (see Chapter 6.7.3), keep the softkey F4 pressed, and switch
on the supply voltage.
310
Boot Loader Message of Run Application
Information in the Boot Loader
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018