ABB DressPack Product Manual page 80

2 Installation
2.4.3.2 Fitting the cable package IRBDP MH3 UI
Continued
3
4
5
6
Connect the cable package
1
2
Continues on next page
80
Action
Carefully push the cable package back into the
tube and out through the insert until the area
where grease was applied, is visible and able to
reach.
Apply grease on the highlighted area so that the
cable package inside the tube is covered with
cable grease all the way through.
Carefully push the cable package back in through
the insert and into its mounting position in the
tube.
Note
Make sure the cables and hoses are not twisted
through the upper arm.
Action
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot working
area.
CAUTION
The cable package is sensitive to mechanical
damage. Handle it with care in order to avoid
damaging the cabling or the connectors.
© Copyright 2015-2017 ABB. All rights reserved.
Note
xx1400001390
Note
Product manual - DressPack/SpotPack IRB 8700
3HAC055802-001 Revision: B