ABB DressPack Product Manual page 107

Connect the cable package
1
Weld connector
Only valid for IRBDP SW6 UI.
1
Product manual - DressPack/SpotPack IRB 8700
3HAC055802-001 Revision: B
2.4.5.2 Fitting the cable packages IRBDP MH6 UI and IRBDP SW6 UI, Lean ID
Action
Connect the hose and cable connectors on the
connection plate.
CAUTION
Do not tighten the brass couplings for water and
air with excessive force.
Tip
Start connecting top connectors, and continue
downwards.
Action
Press (manually) the cables with the crimped-on
contact part into the insulation from the back until
it perceptibly engages into place to the detent.
Note
Make sure the pins are pushed all the way into
the connector.
© Copyright 2015-2017 ABB. All rights reserved.
2 Installation
Continued
Note
Tightening torque, brass couplings
1/2": 31 Nm
Tightening torque, brass couplings
3/8": 17 Nm
SW-cabling:
xx1500002812
MH-cabling:
xx1500003038
Note
xx1400000216
Continues on next page
107