ABB DressPack Product Manual page 196

4 Repair
4.2.4 Replacing the cable packages IRBDP SW6 UI and IRBDP MH6 UI LeanID
Continued
5
Apply cable grease
It is necessary to apply cable grease on the cable package inside the tube.
1
2
3
4
5
6
Continues on next page
196
Action
Carefully push the cable package into the insert,
through the tube and out in the back of the arm
housing.
Tip
The following order is preferable:
1 Cables
2 Hoses
3 Weld cables (where applicable)
If there is a problem, remove the nut inside the
tube.
Action
Carefully pull the cable package out 10 to 15
centimeters longer than the final assembly positi-
tion.
Apply grease on the highlighted area.
Carefully push the cable package back into the
tube and out through the insert until the area
where grease was applied, is visible and able to
reach.
Apply grease on the highlighted area so that the
cable package inside the tube is covered with
cable grease all the way through.
Carefully push the cable package back in through
the insert and into its mounting position in the
tube.
Note
Make sure the cables and hoses are not twisted
through the upper arm.
© Copyright 2015-2017 ABB. All rights reserved.
Note
xx1400000095
Note
xx1400001389
xx1400001390
Product manual - DressPack/SpotPack IRB 8700
3HAC055802-001 Revision: B