ABB DressPack Product Manual page 118

2 Installation
2.8.1 DressPack - arm load parameters and LoadId
Continued
The used arm load is defined for each arm, irb_1, irb_2, and irb_3.
Procedures Step 2 - Load Identification
It is recommended to use the service routine Load Identification (LoadID) to define
the load data for an individual robot, as this method not only measures the mass
but also the inertia of the tool.
Detailed in Operating manual - IRC5 with FlexPendant.
1
2
3
4
5
6
118
• load:_3
Action
Check if the cable package prevents move-
ments.
If not:
Run Load Identification.
If the cable package prevent the motions:
Remove the cable package.
Make the Load Identification.
Refit the cable package.
Add the DressPack load manually.
© Copyright 2015-2017 ABB. All rights reserved.
Note
If the cable package prevent the motions.
The DressPack forces on the wrist will
"increase" the load parameters, but this
is anyhow a good approximation of the
actual load case to be considered by the
motion planning functions of the robot.
See Procedures Step 1 - Arm load data
on page 117.
Product manual - DressPack/SpotPack IRB 8700
3HAC055802-001 Revision: B