Fitting The Process Turning Disc - ABB DressPack Product Manual

2.3 Fitting the process turning disc

Location of the process turning disc
The process turning disc is located in the front of the wrist housing as shown in
the figure.
xx1500003047
Required tools and equipment
Equipment, etc.
Standard toolkit
Roundsling 1 m
Fitting the process turning disc
Screw joints for fitting the process turning disc
Variant
3HAC051003-005
Product manual - DressPack/SpotPack IRB 8700
3HAC055802-001 Revision: B
Article number
-
-
Screw dimen-
sion
M12x40
© Copyright 2015-2017 ABB. All rights reserved.
2.3 Fitting the process turning disc
Note
Content is defined in section
toolkit on page 233.
Lifting capacity: 1,000 kg
Number of Number of
screws washers
22 pcs 22 pcs
Continues on next page
2 Installation
Standard
Tightening
torque
120 Nm
59