Technical Data Of The Operator Panel With Display - Siemens SIMOCODE pro C System Manual

15.8.2

Technical data of the operator panel with display

Technical data of the operator panel with display
Mounting
LED displays
Red / green / yellow "DEVICE"
•
LED
Green "BUS" LED
•
Red "GEN. FAULT" LED
•
4 green LEDs
•
Display
Buttons
Control buttons
•
Arrow keys
•
Softkeys
•
System interfaces
Front
•
Rear face
•
Note
Product version of the operator panel with display
• For use with the SIMOCODE pro V PN/pro V EIP basic units, an operator panel with
display version *E07* or higher is required
• For use with the SIMOCODE pro V MB basic unit, an operator panel with display
version *E09* or higher is required.
SIMOCODE pro
System Manual, 05/2019, A5E40507475002A/RS-AD/004
Installation in a cabinet door or in a front panel, with IP54 system interface cover.
Red blocked: "Function test negative, device disabled"
•
Green: "Ready for operation"
•
Flashing green: "No connection to basic unit"
•
Yellow: "Memory module or addressing plug detected"
•
OFF: "No control supply voltage"
•
Continuous light: "Communication with PLC/PCS"
•
Flashing: "Baud rate recognized/communication with PC/PG"
•
Continuous light/flashing: "Feeder fault," e.g. overload tripping
•
For freely assigning any status signals (preferably for feedback on the switching
state, e.g. ON, OFF, CCW, CW)
Graphic display of current measured values, operating and diagnostics data or status
information.
Control of the motor feeder, freely assignable
•
Navigation in the display menu
•
Various functions, depending upon the menu, e.g. test, reset, operation of
•
memory module and addressing plug
For connecting a memory module, an addressing plug, or a PC cable for
parameterization purposes
Connection to the basic unit or to an expansion module
15.8 Technical data of the operator panels
Technical data
361