Siemens SIMOCODE pro C System Manual page 395

Station
A device that can send, receive or amplify data via the bus, e.g. master, slave.
Statistical data
SIMOCODE pro makes statistical data available, which can be read out, for example, with
SIMOCODE ES (TIA Portal) under Commissioning → Service Data / Statistical Data.
STEP7
The basic STEP 7 software is the standard tool for the SIMATIC S7, SIMATIC C7, and
SIMATIC WinAC automation systems.
Stop category 0
Non-controlled shutdown by immediately switching off the power to the machine's drive
elements.
System interface cover IP54
Cover to protect the system interface on the door adaptor or on the operator panel/operator
panel with display from soiling or to seal it.
Temperature module (TM)
The temperature module offers the option of expanding the SIMOCODE pro V device series
by an analog temperature monitoring system. With this, up to three analog sensor measuring
circuits (two-wire or three-wire systems) can be connected. The temperatures recorded can
be fully integrated into the process, can be monitored and are also available for a higher-
level automation system. You can, for example, implement analog temperature monitoring of
the motor windings, bearings, coolant or gearbox oil. SIMOCODE pro V supports various
sensor types (NTC, KTY83/84, PT100 and PT1000) for use with solid, liquid, or gaseous
media.
Temperature monitoring
See temperature module (TM).
Terminal block
Insulating part comprised of one or more terminals, insulated from one another, for mounting
on a strip.
SIMOCODE pro
System Manual, 05/2019, A5E40507475002A/RS-AD/004
Glossary
395