Technical Specifications Of The Simocode Pro C / Pro S / Pro V Pb / Pro V Mr Basic Units - Siemens SIMOCODE pro C System Manual

Technical data

15.2 Technical specifications of the SIMOCODE pro C / pro S / pro V PB / pro V MR basic units

15.2 Technical specifications of the SIMOCODE pro C / pro S /
pro V PB / pro V MR basic units
Technical specifications of the SIMOCODE pro C / pro S / pro V PB / pro V MR basic units
Mounting
Cabinet mounting basic unit SIMOCODE pro S
(3UF7020)
Display
Red / green / yellow "DEVICE" LED
Green "BUS" LED
Red "GEN. FAULT" LED
"TEST/RESET" button
System interfaces
Front, right-hand side (pro S)
Bottom, front (pro C, pro V)
Front, left-hand side (pro S)
PROFIBUS DP interface
Interface (physical)
332
Snap-mounted onto 35-mm standard mounting rail or screw-mounted
using additional push-in lugs
Minimum distance to be maintained
from cabinet rear wall for series mounting at side: 0 mm
•
from grounded parts at side: 2 mm
•
Red: "Function test negative, device disabled"
•
Green: "Ready for operation"
•
Yellow: "Memory module or addressing plug detected"
•
OFF: "No control supply voltage"
•
Continuous light: "Communication with PLC/PCS"
•
Flashing: "Baud rate recognized/communication with PC/PG"
•
Continuous light/flashing: "Feeder fault," e.g. overload tripping
Resets the device after tripping
•
Function test (system self-test)
•
Operation of memory module or addressing plug
•
For connecting an operator panel or expansion modules. The memory
module, addressing plug or a PC cable can also be connected to the
system interface for parameterization purposes.
Connection of a current measuring module or a current/voltage
measuring module
Connection of a current measuring module
RS485
System Manual, 05/2019, A5E40507475002A/RS-AD/004
SIMOCODE pro