Siemens SIMOCODE pro C System Manual page 114

Description of system components
8.3 Operator panel with display
● Calculator 2
Shows the calculated result that the function block Calculator 2 provides without units in the
range 0 ... 65535.
Permits display, for example, of a 2-byte or 4-byte value sent directly from the automation
system on the display of the switchboard or the display without units of each 2-byte and 4-
byte value in SIMOCODE pro.
● Energy consumed
Note
Modified system expansion or hardware configuration
If the main display permanently fails to show measured values, this indicates that a profile
has been selected in the display settings that is no longer supported, due, for example, to a
changed system expansion or changed hardware configuration. The profile must be
reselected.
1) Possible only if a current measuring module or current / voltage measuring module is
used
2) Possible only if a current / voltage measuring module is used
3) Possible only if a current / voltage measuring module is used Values will only be displayed
if phase voltage is set/configured
4) Possible only if a current / voltage measuring module is used and line-to-line voltage is
set/configured
5) Possible only if the analog module is used
6) Possible only if the temperature module is used
7) Possible only if a current / voltage measuring module and temperature module are used
Values will only be displayed if phase voltage is set/configured
114
2)
System Manual, 05/2019, A5E40507475002A/RS-AD/004
SIMOCODE pro