Siemens SIMOCODE pro C System Manual page 89

Note
Modification of selected device parameters via the operator panel with display
Modification of selected device parameters is possible via the operator panel with display
(see Parameters (Page 124))
The following figure shows an operator panel with display:
Figure 8-6
The operator panel with display can be connected directly to basic unit SIMOCODE pro V or
an expansion module via the rear system interface. Voltage is supplied by the basic unit.
This front system interface (with cover for IP54) can be used to connect (by means of the PC
cable) a PC with the SIMOCODE ES (TIA Portal) software installed or the memory module
and the addressing plug.
NOTICE
Active operation
You must not remove or plug in the operator panel with display during operation!
Note
When using an operator panel with display, you may have to consider restrictions in the type
and number of expansion modules that can be connected to a basic unit!
See Chapter Configuration information for SIMOCODE pro V when using an older basic unit
(Page 155).
SIMOCODE pro
System Manual, 05/2019, A5E40507475002A/RS-AD/004
Operator panel with display
Description of system components
8.3 Operator panel with display
89