Siemens SIMOCODE pro C System Manual page 404

Index
Mounting current measuring modules / current/voltage
measuring modules, 340, 342
Mounting decoupling module, 345
Mounting digital modules, 346
Mounting digital modules DM-F, 347
Mounting lugs, 185, 189, 191
Mounting of basic unit and multifunction module,
SIMOCODE pro S, 187
Mounting of the basic unit, 337
Mounting of the operator panel with display, 361
Mounting operator panels (OP), 193
Mounting position, 330, 337
Mounting temperature module, 356
Mounting the current measuring modules, 189
Mounting the initialization module in the
switchboard, 167
Mounting the operator panel, 193, 360
Mounting the operator panel adapter, 284
Mounting the operator panel with display, 194
Mounting, wiring, and interfaces of digital modules
DM-F Local and DM-F PROFIsafe, 189
Multifunction module, 74
Multifunction module (MM), 154
N
Newsletter, 17
No start permitted, 295
Non-volatile elements, 58
O
OPC UA, 55
Operating data, 42, 59
Operating hours monitoring, 41
Operating instructions, 11, 255
Operating Instructions, 305, 318
Operating instructions and other manuals, 11
Operation as DPV1 slave downstream from the
Y-Link, 54
Operational Protection Off, 57
Operational Protection Off (OPO), 292
Operator controls and display elements, system
interfaces basic units, 84
Operator controls of the operator panel with display, 93
Operator panel, 27, 68, 85
Operator panel adapter, 77, 177
Operator panel with display, 27, 68, 88
Operator panel with display (OPD) timing chart, 94
Outputs of the analog module, 352
Overload, 300
404
Overload and unbalance, 300
Overload protection, 41, 47
Overload relay, 42, 53, 83
P
Parameter changes not allowed in the current
operating state, 296
Parameter is incorrect ("Event" category), 296
Parameter settings in the "SIMOCODE ES
(TIA Portal)" software, 164
Parameterization methods, 256
Parameters, 109, 124
Saving from basic unit to SIMOCODE ES file, 278
Saving from memory module to basic unit, 277
Saving to the memory module, 277
Parameters, operator panel with display, 103
PC cable, 236
PC cable for connecting a PC / PG, 243
Performance characteristics, 41
Performance Level, 52, 148
Periodic tests of the device for control of ignition
sources, 326
Permissible ambient temperature, 329
Permissible number of starts exceeded, 301
Phase failure protection, 41, 47
Phase sequence, 135
Phase sequence detection, 51
Phase unbalance, 297
Pin assignment for SIMOCODE pro C / pro V PB basic
units, 199
Pin assignment for SIMOCODE pro V PN / EIP basic
units, 202
Pin assignment for SIMOCODE pro V PN GP basic
unit, 201
Pin assignments of the removable terminals of the
1st generation current / voltage measuring
modules, 232
Pin assignments of the removable terminals of the
2nd generation current / voltage measuring
modules, 231
Pin assignments of the removable terminals of the
basic unit, 201, 202
Pole-changing reversing starter, 42
Pole-changing starter, 42, 53, 83
Positioner, 42, 53
Positioner control, 83
Power consumption, 334
Power consumption DM-F digital modules, 347
Power failure (UVO), 296
Power failure backup time basic unit, 334
Power failure back-up time digital modules DM-F, 348
System Manual, 05/2019, A5E40507475002A/RS-AD/004
SIMOCODE pro