Making Rear Panel Connections
MDXII master/slave systems operates more reliably and is less sensitive to spurious noise if
both the MDXII chassis and the system are grounded. The preferred method of chassis
grounding is to daisy-chain a flat copper braid of AWG-10 equivalence between units. Use
only one lead to connect the system ground block to the daisy-chained units.
Setting Up for master/Slave or Stand Alone Operation
This procedure describes the process to convert a stand alone 30 kW into a master/slave
system and how to convert a master/slave system into a stand alone power supply. It is
important to follow this procedure because incorrect switch settings may cause damage to the
process and the power supply. Refer to Figures 3-15 and 3-16 for board and switch locations.
Figure B-2. Transducer board location
5700262-R
MDXII Power Supplies
B-13