Host/Mdxii Communications Commands; Table B-9. Communications Commands - Advanced Energy MDX II User Manual

®
Advanced Energy

Host/MDXII Communications Commands

Table B-9. Communications Commands

Command
162
rpt process status
B-10
Description and Comments
Requests report on process status. Returning packet
contains four data bytes (8-bit value). see the illustration
below and on the next page.
Note: If the run is active bit and the fast run is active bit (bit
2 and bit 3 of the first status byte) are both true at the
same time, this means that you have fast ramp/run
available but have set a run time of greater than 1 s.
First Status Byte
0 = Ramp is active
1 = Fast Ramp is active
2 = Run is active
3 = Fast run is active
4 = Ramp direction (0=up, 1=down)
5 = Output power (0=off, 1=on)
6 = Main contactor (0=open, 1=closed)
7 = Setpoint status (0=within tolerance, 1=out of
tolerance)
Second Status Byte
0 = End of target life
1 = Untimed run active
2 = A/D conversion failure
3 = Overtemperature
4 = Module interlock open
5 = Water interlock open
6 = Vacuum interlock open
7 = Auxiliary interlock open
Third Status Byte--fault flags
0 = Momentary power fluctuation
1 = Soft-start failure
2 = Configuration fault
3 = Stuck push button
4 = Front panel common fault
5 = Out of setpoint
6 = Bus 1 high
7 = Bus 2 high
5700262-R