Advanced Energy MDX II User Manual page 143

Table 7-9. AE Bus and Profibus Communications Commands (Continued)
Command Used By
AE
√
10
Varc trip
level
√
11
target select
5700262-R
Description
Pro
√
Specifies how many volts
will constitute an arc (see
Command 31); accepts a
value of 25 to 400 V (no
implied decimal).
Read back this value with
Command 173.
√
Specifies which target will
be active; accepts a value of
1 to 8.
Note: The User port has
priority for target
selection. Thus, to
select targets from a
serial port, you must
set the target to 1 at
the User port. Leaving
the target bits open or
leaving the User port
pins unconnected
causes the target
selection at the User
port to default to 1.
Read back this value with
Command 156.
Serial Port Connection, Controls and Indicators
MDXII Power Supplies
Host Data ResponseData
Bytes Bytes
AE Pro AE
2 2 1
1 1 1
Pro
0
0
7-23