Setting Run Time - Advanced Energy MDX II User Manual

®
Advanced Energy

SETTING RUN TIME

See "Run Timer" on page 5-2 for a description of this function.
⇒
TIMERS RAMP/RUN
1. At the top-level menu, press the TIMERS soft key.
2. Press the RAMP/RUN soft key.
3. Set the number of steps (up to five) by turning the MODIFY knob.
If you select more than one step, and if the run timer is not set to zero, pressing the
ENTER soft key causes RAMP 2 TIMER and so on to display until you have set all
values or scrolled past them with the ENTER soft key.
4. Press the ENTER soft key.
5. Either set the RAMP 1 timer or press the ENTER soft key.
6. Either set the SETPOINT 1 value or press the ENTER soft key.
7. Press either the H (hours) or M (minutes) or S (seconds) soft key.
If fast ramp/run is active and the value for both hours and minutes is zero, "MS"
displays, allowing you to enter a value in tens of milliseconds. Conversely, if you have
entered a non-zero value for either hours or minutes, "MS" does not display and you
cannot enter a value for milliseconds. Note that if you have entered a non-zero value for
seconds, "MS" still displays.
8. Set the RUN 1 timer by turning the MODIFY knob. Press either of the other soft keys if
you want to set another value.
9. Press the ENTER soft key.
Pressing the ENTER soft key the final time returns you to the output display screen
automatically.
Note: Press the MODIFY knob at any time to return to the output display screen; note that
this disables the recipe (sets the number of steps to zero).
6-8
⇒
Number of steps
Panel Connection, Controls and Indicators
⇒
run n timer
5700262-P