Table of Contents
Advertisement
"Local Service Pages"
"Local Security Pages"
"All Local Pages"
"Video Switcher Restore"
This string is output on any system serial port programmed for "Video Switcher Control" when all alarms are
restored. This string is output to the video switcher to reset it to the default displays.
"Modem Init"
This is the initialization string output to the modem. Normally this setting would not have to be changed. To allow
changes to this string, hold down the SHIFT and CTRL keys when this dialog is first opened. This string is
specific to each modem model.
"Modem Reset"
This is the reset string output to the modem. Normally this setting would not have to be changed. To allow
changes to this string, hold down the SHIFT and CTRL keys when this dialog is first opened. This string is
specific to each modem model.
Transponder Database
The Transponder Database is established at System set-up and contains all necessary configuration data for
each Transponder, receiver and alert unit. It describes the basic structure of the installation, including all device
names, locations, types, Multiplex Addresses, etc. This information is used by the Central Console to generate
"Alarm" and "Test" displays on the Console and in determining which Alert Units are to be activated. Access to
the Transponder Database is from the "File" menu on the Main Menu bar. The following paragraphs describe the
elements of the Transponder Database Dialog.
Security Escort Training
Page 52 of 142
Advertisement
Table of Contents
