Table of Contents
Advertisement
Security System
User Guide
Change Outputs (Cmd 54)
I can perform this command.
I cannot perform this command.
Use this command to turn on and off the outputs programmed by your security company. These outputs can control
outside lighting, pool pumps, watering systems, etc.
1.
Ensure the system is turned off (On indicator is off).
2.
Press [CMD] [5] [4]. The command center may prompt you to enter a valid passcode.
3.
Enter your passcode if necessary. The command center scrolls:
4.
Press [0] [*] if you want to turn all outputs off, or press the output number you want to turn off followed by
[*]. For example, if you want to turn Output 1 off, you press [1] [*]. The command center displays:
5.
Press [CMD] to return the command center to the normal display.
Remote Program (Cmd 43)
I can perform this command.
I cannot perform this command.
Use this command to connect to your security company's remote PC computer for programming alterations via the
telephone line. Only use this command when your security company instructs you to.
1.
Ensure the system is turned off (On indicator Off).
2.
Press [CMD] [4] [3]. The command center may prompt you to enter a valid passcode.
3.
Enter your passcode if necessary. The command center displays:
If your system is busy and cannot call your security company's remote PC computer, the command center
displays:
4.
The command center automatically returns to the normal display when programming is complete.
46841D
Turn all Outputs
Off? Press 0*
Output 1 is On
To turn Off
Press 1*
Output 1 is Off
To Turn On
Remote Program
in progress.
System Busy.
Try again later.
D623/D625 User Guide
Page 36
© 2003 Bosch Security Systems
Advertisement
Table of Contents
