System Setup - First Steps; Introduction; Setup Instruction; Setting The Ip Address - Bosch DIP-6083-8HD Quick Installation Manual

16 en | System Setup – first Steps
4 System Setup – first Steps
4.1

Introduction

The following installation directive provides information on Installation and Configuration.
The DIVAR IP 6000 systems are based on Windows Storage Server 2008 R2 operating system.
Windows Storage Server 2008 R2 systems provide a user interface for initial server
configuration, unified storage appliance management, simplified setup and management of
storage and shared folders, and support for Microsoft iSCSI Software Target.
It is specially tuned to provide optimal performance for network-attached storage. Windows
Storage Server 2008 R2 operating system provides significant enhancements in share and
storage management scenarios, as well as integration of storage appliance management
components and functionality.
This chapter is valid for DIVAR IP models that come with pre-installed hard drives. Empty units
start into the DOM recovery menu on first start. The recovery process and the RAID setup are
described in the installation manual.
4.2

Setup instruction

All systems are pre-configured with a default IP address and with default
iSCSI settings.
–
–
–
–
The default iSCSI settings are optimized for use with VRM. Only an experienced storage
administrator should make changes to these settings.
Changing the default configuration is only required if:
–
–
4.3

Setting the IP address

The default IP address can be changed as follows:
–
–
4.3.1

Remote desktop connection

To start the system:
1.
2014.01 | V4 | DOC
IP Address: 10.10.10.10 (1st port) and 10.10.10.11 (2nd port)
Subnet mask: 255.255.255.0
User: Administrator
Password: WSS4Bosch
VRM is not used (DIVAR IP 6000 as standard iSCSI disk array)
The default settings are not appropriate for another Bosch iSCSI application.
Remote desktop connection
Physical connection
Connect the system to your network through port 1 or port 2 and start the system. The
system comes with the Remote Desktop Connection enabled. Log on to an appropriate
Client system either with Windows XP, Windows Vista or Windows 7 installed (Client
hardware and software is not part of the shipment) with an IP Address in the same
network, for example 10.10.10.12 (net mask: 255.255.255.0).
Quick Installation Guide
DIVAR IP 6000 2U
Bosch Sicherheitssysteme GmbH