Table of Contents
Advertisement
Your phone must be set to send the caller line
i
identification (CLI) information or the SMS
Note
restriction function will not work. Do not enter
international or domestic prefixes when entering
SMS Control numbers. Eg. enter 0423584578 and
not +612423584578
System Events
Options in this section relate to programming of system
wide options and interpretation of system trouble events
when and if they occur. Some events such as open zones
will appear as single events while others may be grouped
together. In this case you need to drill down to see the
specific detail for each event.
Your installer will advise you how to interrogate system
trouble events.
System > Commands >
Panel Status
The panel staus menu displays the panel software version
information as well as highlighting any system troubles
that are currently in effect. This is a view only location.
Line 1 Displays:
The panel number that you are getting information from.
The Solution 6000 is only configured to work with one
panel.
Line 2 Displays:
The panel name and firmware version number.
Line 3 Displays:
The current panel temperature, panel power supply
voltage and any system troubles which are in effect. This
line scrolls all events continiously.
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [7] + [0] + [0] to view the panel
status.
Panel 1
Solution 6000 Ver 2.00.00
Temperature = 33
Press OK or MENU
2. Press [OK] to exit when finished.
System > Commands >
System Trouble
The System Trouble Menu displays all current system
troubles in a list format. Some trouble events require you
to drill down to fully interpret while others such as an
unsealled zone can be interpreted at the top level. "Table
8: Control Panel Trouble Messages" on page 38 lists the
various trouble conditions that may be displayed and their
Bosch Security Systems 3/23 BLCC610U
meanings.
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [7] + [0] + [1].
The keypad will display a list of all current system
and non system trouble conditions.
To determine the system trouble condition,
highlight the panel number (P001) that you want to
view using the [] and [] keys, then press [OK] to
select.
To determine the non system (zone) trouble
condition, highlight the zone number Zn1 to Zn144)
that you want to view using the [] and [] keys,
then press [OK] to select.
MENU 7-0-0
2. If viewing system trouble conditions, the keypad
will display similar to the following:
The third line of the keypad display scrolls between
all current system trouble events.
If viewing non-system trouble conditions, the
keypad will display similar to the following:
3. Press [OK] or [MENU] to exit the system trouble
menu command:
If there are no system troubles, the keypad will
display:
MENU 7-0-1
Refer to the Trouble Messages table for a complete
list of trouble events and their meanings.
Solution 6000
System Trbl
Zn1 Zone 1 Name
Op3 Output Trouble
Press
OK or MENU
System Trbl
Zn1 Zone 1 Name
Zn2 Zone 2 Name
Press
OK or MENU
Panel 1
Solution 6000 Ver 2.00
Date And Time
Press OK or MENU
Zone 1 Name Zn1
EOL=Open 55968 ohms
Press OK or MENU
There are no
system troubles.
Press
OK or MENU
User Guide
37
Advertisement
Table of Contents
