Setup Part 3: Vlans - Lenovo Flex System Fabric CN4093 Application Manual

Setup Part 3: VLANs

1. Select the VLAN to configure, or skip VLAN configuration at the prompt:
2. Enter the new VLAN name at the prompt:
3. Enter the VLAN port numbers:
4. Configure Spanning Tree Group membership for the VLAN:
5. The system prompts you to configure the next VLAN:
66
CN4093 Application Guide for N/OS 8.4
If you chose to skip VLANs configuration back in Part 2, skip to "Setup Part 4: IP
Configuration" on page
VLAN Config:
Enter VLAN number from 2 to 4094, NULL at end:
If you wish to change settings for individual VLANs, enter the number of the
VLAN you wish to configure. To skip VLAN configuration, press <Enter> without
typing a VLAN number and go to "Setup Part 4: IP Configuration" on page
Current VLAN name: VLAN 2
Enter new VLAN name:
Entering a new VLAN name is optional. To use the pending new VLAN name,
press <Enter>.
Define Ports in VLAN:
Current VLAN 2: empty
Enter ports one per line, NULL at end:
Enter each port, by port number, and confirm placement of the port into this
VLAN. When you are finished adding ports to this VLAN, press <Enter> without
specifying any port.
Spanning Tree Group membership:
Enter new STG index [1-128](802.1d)/[1](RSTP)/[0-32](MSTP):
VLAN Config:
Enter VLAN number from 2 to 4094, NULL at end:
Repeat the steps in this section until all VLANs have been configured. When all
VLANs have been configured, press <Enter> without specifying any VLAN.
67.
67.