Table 14: Web - Rf Mode - Rf Port Settings For Wireless Link; Fig. 57: Web - Stickiness Timer Example - Redline RDL-3000 Series User Manual

RDL-3000 FAMILY
Stickiness Timer (Seconds): Period the subscriber continues to monitor the RF
channel for an opportunity to re-establish a link with the same sector controller. If the
wireless link is not restored within the specified period of 0 - 600 seconds, the subscriber
starts a new frequency scan.
This timer is active only when Auto Scan is enabled. This timer can be set locally on the
subscriber Wireless settings screen. This value is downloaded and overrides the local
setting on the subscriber. Updates to the sector controller setting are automatically
forwarded to connected RAS platforms. The subscriber reverts to the local setting when
a rescan in started (e.g., Stickiness Timer expired). The System Status screen displays
the active Stickiness Timer value.
Operating Mode: Choose the mode of operation for this wireless link.
The available operating modes are controlled by the installed options key (
example, the radio may be restricted to MIMO A operation.
MIMO A: Operate in MIMO-A mode (based on link conditions).
MIMO A/B: Operate in MIMO-A/B mode (based on link conditions).
RF Mode: Select the mode of operation for this link (refer to the following table).
The available RF modes are controlled by the installed options key (
the radio may be restricted to MIMO-A operation.

Table 14: Web - RF Mode - RF Port Settings for Wireless Link

RF Mode Setting
RF Port 1
RF Port 2
RF Port 1&2
Auto
RF Port 1
RF Port 2
RF Port 1&2
Auto
* Equivalent to RF Port 1 & 2.
Important:
Controls
Apply: Click to accept and activate displayed settings.
70-00158-03-00
USER MANUAL

Fig. 57: Web - Stickiness Timer Example

Settings
Operating Mode
MIMO-A
MIMO-A /B
Links to AN-80i subscribers must be configured to use MIMO A mode
(RF Port 1 or RF Port 2).
Proprietary Redline Communications © 2015
Operation
RF Port 1 RF Port 2
X
X
Auto Auto
X
X
Auto Auto
Page 97 of 254
). For
). For example,
Op. Mode
MIMO-A
MIMO-A
MIMO-A
Automatic*
MIMO-A
MIMO-A
MIMO-A / B
Automatic*
April 17, 2015