RDL-3000 FAMILY
2. Scanning channels in 360 degrees: ~15 s setup + (N channels x 0.5)
3. Set beam position and monitor for opportunity to join network (90 s max.).
4. Link is up. RDL-3000 is actively monitoring UBR for UL and DL.
5. Detect UL and/or DL UBR < threshold. Start Re-scan Interval timer.
6. Re-scan Interval timer expired. RDL-3000 drops link and starts new scan (go to 2).
7.8
Link Layer Discovery Protocol (LLDP) Support
Software version 2.23/2.25 Update 9 and higher supports LLDP. Each Redline LLDP
Data Unit (Frame) consists of the following TLVs:
TLV_CHASSIS_ID
TLV_PORT_ID
TLV_TIME_TO_LIVE
TLV_PORT_DESC
TLV_SYSTEM_NAME
TLV_SYSTEM_DESC
TLV_MGMNT_ADDR
TLV_ORG_SPECIFIC-TIA-INVENTORY *
TLV_ORG_SPECIFIC-TIA-INVENTORY *
TLV_ORG_SPECIFIC-TIA-INVENTORY *
TLV_ORG_SPECIFIC-802.3-POWER
TLV_ORG_SPECIFIC-REDLINE-WIRELESS *
TLV_END
* Not present on revisions of RDL-3000 hardware with serial number prefixes 100-148.
Field
Size
Value
1. Frequency in KHz
2. Channel size in MHz: 0=3.5, 1=7, 2=14, 3=5, 5=20, 6=40, 7=28
3. Power in dBm
4. Link Status: 0=down, 1=up
70-00158-03-00
Fig. 71: Ref: Scan Threshold Configuration Settings
Table 38: Ref. – Redline LLDP Data Unit (Frame) TLVs
Table 39: Ref. - Redline-Specific LLDP TLV
TLV
Length
OUI
Type
7 bits
9 bits
3 octets
127
11
00 09 02
Proprietary Redline Communications © 2015
USER MANUAL
MAC of the radio
Ethernet interface name in binary form
Time the receiver should keep the content of
the LLDP packets
Ethernet interface name in ASCII form
System name ('RDL-3000 USN')
System description ('RDL-3000 USN,Redline
Communications Inc. - www.rdlcom.com')
IP address of the RDL-3000 system
Inventory TLV with serial number of the radio
Inventory TLV with software version
Inventory TLV with manufacturer name
TLV with power requirement for the RDL-3000
Redline-specific TLV (see below)
Subtype
RF
Frequency
1 octet
4 octets
1
Note 1
Channel
Power
Size
(dBm)
1 octet
1 octet
Note 2
Note 3
Page
170
of 254
Link
Status
1 octet
Note 4
April 17, 2015