Page 2
All rights reserved September 21, 2017. The information in this document is proprietary to Redline Communications Inc. This document may not in whole or in part be copied, reproduced, or reduced to any medium without prior consent in writing from Redline Communications Incorporated.
This is afterwards referred to as the 'final product'. The final product may be designed and manufactured by Redline or a licensed third party. Frequency settings within the specified frequency ranges are software keyed to be compliant with specific regulatory agency requirements in the region of deployment.
Any operation or use of this module in any manner not expressly specified within this manual or approved in writing by Redline (or its agents) is expressly forbidden and voids the users right to operate the module. This includes, but is not limited to, any modification of the module hardware or software, installation of the module in a non approved enclosure, and use with non approved antennas.
The module must be installed only by trained professional technicians authorized by Redline or its agents. The module must be installed only into an approved enclosure (see Conditions of Use) and only at an approved manufacturing facility or service depot.
A module with a key for client operation can not be changed by the installer to enable master mode operation. Redline will review all final products for compliance to regulatory restrictions. The manufacturer must meet all labeling described in section 2.3.
Operation of the final product requires a software 'key' that is available exclusively from Redline. This key restricts device operation to the FCC/IC 4940-4990 MHz and 5725- 5850 MHz or FCC 5150-5250 MHz MHz band. The professional installer and operator can not modify or otherwise circumvent these operational restrictions.