Command Set; Apply; Chgver - Redline RDL-3000 Series User Manual

RDL-3000 FAMILY
9.6.2

Command Set

apply

Use the apply command to activate changes to the configuration without overwriting the
last saved configuration. This is equivalent to clicking the Apply button in the
configuration screens.
apply <config>
config
Activate all changes to the configuration, but do not save changes permanently in
the non volatile RAM. Use this command in combination with reboot to temporarily
test changes.

chgver

Switch to the binary saved in the alternate version of firmware. Use 'get swver' to list the
active and alternate versions of firmware.
IMPORTANT: This command works silently (no operator confirmation). The serial
gateway reboots immediately.
get <dnsip1 | dnsip2 | gateway | ipaddr | mac | netmask | radio | sysuptime |
swver>
Use the get command to view system parameters. Use the following general format to
view a parameter.
dnsip1
IP address of the Primary DNS server that is actually in use.
8.8.8.8
dnsip2
IP address of the Secondary DNS server that is actually in use.
8.8.4.8
gateway
Default gateway address that is actually in use
10.117.64.250
ipaddr
Unit's IP Address in use.
10.117.64.2
mac
MAC address.
00:09:02:14:04:90
netmask
Unit's IP netmask that is actually in use.
255.255.255.0
radio
detection
Radio device detection.
70-00158-03-00
Radio device related commands
true Radio is present.
false Can not detect radio.
Proprietary Redline Communications © 2015
USER MANUAL
Page 248 of 254 April 17, 2015