Fig. 42: Web - Wireless Configuration Screen -- Subscriber - Redline RDL-3000 Series User Manual

RDL-3000 FAMILY
programmed by the manufacturer or a trained professional installer. Refer to the notices
in Section 1 and Section 7 of this manual.
STID: (SS only) Enter the name of the link template to use when registering with the
sector controller. The RAP (Rapid Auto Provisioning) feature must be enabled by the
options key
Important: You MUST reboot the RDL-3000 after changing the CIR and/or PIR for
any active STID template:
System operators can use the Rapid Auto-Provisioning (RAP) option to pre-provision
wireless links on the sector controller without specifying a remote unit MAC address.
This allows the wireless link configuration to be pre-specified for quick deployment in a
RAP-enabled sector and automatically establish a wireless link with the required
operating characteristics.
Using the RAP feature requires two steps. The first step is to pre-provision one or more
link templates in each sector controller that will support RAP-enabled units operating in
that sector. Creating a RAP 'Template' requires the same information as a standard
wireless link definition, except the MAC address is replaced with an STID name and
STID password, allowing a wireless connection to be made to any remote unit
presenting these credentials.
70-00158-03-00

Fig. 42: Web - Wireless Configuration Screen -- Subscriber

( ).
Proprietary Redline Communications © 2015
USER MANUAL
Page 75 of 254 April 17, 2015