Important Notices; Service & Safety; General Warnings; Safety Warnings - Redline RDL-3000 Series User Manual

Universal wireless transport
Hide thumbs Also See for RDL-3000 Series:
Table of Contents

Advertisement

RDL-3000 FAMILY
1

Important Notices

1.1
Service & Safety

General Warnings

Redline recommendations for maximum safety include the following:
Do not operate microwave equipment without first having proper training or
knowledge of microwave radio operation.
Do not operate the microwave equipment without an appropriate antenna port
termination, or antenna.
Check to ensure that the area around the antenna is clear of personnel prior to
turning the transmitter on.
Do not look into or stand in front of an antenna.
Do not swing or aim an antenna at nearby persons while the equipment is operating.
Where a structure or rooftop has existing antennas installed, do not proceed with an
installation without first determining the RF/µW exposure risk. Where necessary
have the relevant transmitters turned off or wear a protective suit for the duration of
the installation.

Safety Warnings

Installation of the system must be contracted to a professional installer.
Customer equipment including personal computers, routers, etc., must be connected
only to the INPUT (DATA) port on the PoE unit.
Only the outdoors Ethernet interface cable connecting to the unit can be safely
connected to the OUTPUT (DATA & POWER) connector. Connecting customer
premises Ethernet equipment directly to the OUTPUT (DATA & POWER) connector
on the Power-over-Ethernet power adapter may damage customer equipment.
Read this manual and follow all operating and safety instructions.
Keep all product information for future reference.
The power requirements are indicated on the product-marking label. Do not exceed
the described limits.
The unit must not be located near power lines or other electrical power circuits.
Disconnect the power before cleaning, or when the unit is not be in-use for an
extended period.
The system must be properly grounded to protect against power surges and
accumulated static electricity. The user is responsible for installing this device in
accordance with the local electrical codes: correct installation procedures for
grounding the unit, mast, lead-in wire and discharge unit, location of discharge unit,
size of grounding conductors and connection requirements for grounding electrodes.
70-00158-03-00
PoE power adapter caution:
Warning to Service Personnel: 48 VDC
Proprietary Redline Communications © 2015
USER MANUAL
Chapter 1
Page
16
of 254
April 17, 2015

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents