Network Connection; Fig. 17: Web - Connecting The Ethernet Port To A Pc - Redline RDL-3000 Series User Manual

RDL-3000 FAMILY
3.2

Network Connection

The RDL-3000 can be configured and monitored using a PC equipped with a standard
Ethernet port and a Web browser (Internet Explorer 6.0 or higher) or Telnet client. Refer
to the following diagram for basic connections. The following diagram applies to all RDL-
3000 family products.
Notes:
This diagram does not illustrate the surge protection required for outdoors
1.
installation of the RDL-3000 equipment. The system must be properly grounded to
protect against power surges and accumulated static electricity. Refer to the RDL-
3000 Installation Guidelines manual.
Both RF ports must always be electrically terminated to an antenna or other RF
2.
terminator device when the RDL-3000 is powered-on.
When operating in MIMO-A mode, the unused RF port must be electrically
3.
terminated. SISO mode is not available in v3.00 and higher.
Do not disconnect any RF cable while the RDL-3000 is powered-on.
4.
Failure to follow these requirements may damage the RDL-3000 unit, requiring that
the unit be returned for factory repair.
Use the following steps to establish a Web session with the RDL-3000.
The IP address and subnet mask of the PC must be on the same subnet as the RDL-
1.
3000. For example:
On the test PC, open a browser and enter the unit RDL-3000 IP address.
2.
When the dialog screen is displayed, enter the username and password to login. The
3.
factory default username is 'admin', and the default password is 'admin'.
If the login was successful, the General Information screen is displayed in the Web
4.
browser.
70-00158-03-00
USER MANUAL

Fig. 17: Web - Connecting the Ethernet Port to a PC

Test PC
IP Address: 192.168.25.11
Net Mask: 255.255.255.0
Proprietary Redline Communications © 2015
RDL-3000
(default)
192.168.25.2
255.255.255.0
Page 41 of 254 April 17, 2015