Radius; Fig. 33: Web - Radius Configuration Screen - Redline RDL-3000 Series User Manual

RDL-3000 FAMILY
Rapid path: Check this box
This feature is designed for networks where packet source and destination is changing
from an uplink/downlink perspective. With Rapid Path enabled, the RDL-3000 system
quickly adapts its classification and switching engines to manage these changes.
rapidpath <off | on> Disable or enable the Rapid Path feature
off
on
This feature is can be employed where hosts/CPEs connect to the network using one of
several available remote terminals and for redundancy scenarios:
Ring Redundancy: An RDL-3000 system (typically PTP) is deployed as a
segment in a redundant ring where alternative data paths are provided. A failure
on the primary path may result in reversed traffic flow through the ring (from the
RDL-3000 perspective).
Redundant Remote Terminals: Two co-located RDL-3000 wireless terminals
communicating with the same base station and network path convergence is
controlled by one of several available switching protocols (e.g. PRP or RSTP).
Redundant Base Station: Rapid Path introduces enhanced functionality to the
Redundant base Station solution that transitions packet switching from the
master to the slave sector controller within seconds of a failover event. It is
recommended to always deploy Rapid Path with the Base Station Redundancy
solution.
3.5.2

RADIUS

When Radius or Local + RADIUS is checked
main menu to display the RADIUS Configuration screen. Support includes RADIUS-
based two-factor user-management authentication (e.g., RSA's SecureID platform).
The following fields are provided for configuring the RADIUS server:
Server Enable: Control the RADIUS server mode.
Disabled ( ):.Do not use the RADIUS server for user authentication. This unit
uses only local user authentication
Enabled ( ): Use the RADIUS server for user authentication.
Server IP Address: RADIUS server IP address.
Server Auth-port: Listening port address on RADIUS server (default port is 1812).
70-00158-03-00
USER MANUAL
to enable the Rapid path feature.
Rapid Path feature is disabled.
system will respond to changes in traffic flow.

Fig. 33: Web - RADIUS Configuration Screen

Proprietary Redline Communications © 2015
, click Configuration->RADIUS
(Utilities->Users Management).
Page 66
in the
of 254 April 17, 2015