Warning Symbols; Installation Safety; Professional Installation / Installations Professionnel; Safety Precautions - Redline RDL-3000 Series User Manual

RDL-3000 FAMILY USER MANUAL

Warning Symbols

These symbols may be encountered during installation or troubleshooting. These
warning symbols mean danger. Bodily injury may result if you are not aware of the safety
hazards involved in working with electrical equipment and radio transmitters. Familiarize
yourself with standard safety practices before continuing.
WARNING
WARNING
WARNING
HOT SURFACE
ELECTRO-MAGNETIC
HIGH VOLTAGE
RADIATION
DO NOT TOUCH
1.2

Installation Safety

Professional Installation / Installations Professionnel

Redline RDL-3000 systems require professional installation. The user is responsible to
ensure all building and safety codes are met and the installation is complete and
secure.
The RDL-3000 system shall be installed according to local Electrical Safety Codes.
For Canadian installations, the entire equipment installation must comply with the
Canadian Electrical Code. For installations in the United States, the entire equipment
installation must be in accordance with Article 810 of the United States National
Electrical Code.
Les appareils RDL-3000 de Redline doivent être installés par un personnel
professionnel. Le personnel responsable doit s'assurer que l'installation est bien
achevée, et qu'elle répond aux exigences de tous les codes de sécurité.
Le RDL-3000 doit être installé conformément aux codes locaux de sécurité électrique.
Pour les installations Canadiennes, l'installation de l'équipement au complet doit se
conformer au Code Canadien de l'électricité. Pour les installations aux États-Unis,
l'installation de l'équipement au complet doit être en conformité avec l'article 810 du
Code des États-Unis National Electrical.

Safety Precautions

Installation and service must be done by personnel having technical training and
experience necessary to be aware of hazards during installation and/or service of
outdoors RF equipment. The installation and/or service must be done using procedures
designed to minimize any danger to technical personnel or any other person.
Use safety devices when working on or around the mast. Be aware of the risk of falling
objects. Use provided safety catches when hoisting antennas and radios.
Do not use any components (screws, nuts, etc.) other than those delivered together with
the Redline microwave radio equipment or those recommended by Redline.
Electrocution Hazard / Risque D'électrocution
Warning to Service Personnel: 48 VDC
This product is intended to be connected to a power source as per IEEE 802.3at (42.5
- 57.0 VDC), which must be electrically isolated from any AC sources and reliably
connected to Earth ground. Do not install Redline products near any type of power line.
Should the antenna or related hardware come in contact with power lines, severe bodily
harm or death could result!
70-00158-03-00 Proprietary Redline Communications © 2015 Page 17 of 254 April 17, 2015