Serial Gateway Cli Interface; Quick Reference; Table 162: Serial Gateway Cli - Command Summary; Table 163: Serial Gateway Cli - General Commands - Redline RDL-3000 Series User Manual

RDL-3000 FAMILY
9.6

Serial Gateway CLI Interface

This section describes the procedures for configuring and operating the RDL-3000 using
CLI over a Telnet connection.
Note: Do not logout or issue new commands until the previous CLI command has
finished processing. For 'save config' or 'script' commands this may be approximately
three seconds. When writing script files, insert pauses after these commands.
9.6.1

Quick Reference

Online help is available for all commands. Use the Tab key for auto-complete functions.
The following table lists all available commands.
Command
apply
chgver
exit
get
restart
save
set
show
upgrade
user
Command
Allowed
Characters
Tab
?
CTRL-Z
exit
logout
70-00158-03-00
USER MANUAL

Table 162: Serial Gateway CLI - Command Summary

Description
Apply commands.
Change the software running version to the alternate one.
Exit from the intermediate mode or Quit the CLI session
value of a parameter.
Restart commands.
Save commands.
Set (or show) the value of a parameter
Show commands (not implemented).
Upload from file a new software via specified TFTP or FTP
server.
User management commands.

Table 163: Serial Gateway CLI - General Commands

Description
Alpha-numeric characters including a-z, A-Z, 0-9, dash (-), and
underscore (_).
When entering a command, hit the Tab key at any time to perform auto-
complete or view available options.
Use the '?' character to display help for any command or mode.
Example: From the root directory, enter the following command to list all
parameters that can be changed using the 'set' command:
set ?
Return to root mode.
Cancel command entry (alternative to backspace delete).
Return to parent node / mode.
all (exit all) Return to root mode.
Terminate this telnet session. May be entered from any mode.
Proprietary Redline Communications © 2015 Page 247 of 254 April 17, 2015