Deployment In Canada; Industry Canada Notices; Table 50: 2305-2360 Mhz Recommended Safe Distances In Canada - Redline RDL-3000 Series User Manual

RDL-3000 FAMILY
8.4.1

Deployment in Canada

Industry Canada Notices

This Class B Digital apparatus meets all the requirements of the Canadian Interference-
Causing Equipment.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
The following notices about deployment in Canada are included in training and
documentation provided to professional installers and operators of the final product:
The final product must be professionally installed.
1.
WARNING -- IC RF Exposure Warnings
2.
To satisfy IC RF exposure requirements for RF transmitting devices, the following
distances should be maintained between the antenna of this device and persons
during device operation:

Table 50: 2305-2360 MHz Recommended Safe Distances in Canada

Frequency (MHz)
2305 - 2320
2345 - 2360
2400 - 2483.5
To ensure compliance, operation at closer than these distances is not
recommended. The antenna used for this transmitter must not be collocated in
conjunction with any other antenna or transmitter.
The equipment has been designed to operate with an antenna having a maximum gain
of 17 dBi. Antenna having a higher gain is strictly prohibited per regulations of Industry
Canada. The required antenna impedance is 50 ohms.
This device has been designed to ensure that radio frequency emissions are maintained
within the band of operation under all normal operating conditions listed in this manual.
IC regulations governing operation in the 2305-2320 MHz and 2345-2360 MHz bands
are subject to licensing, pursuant to subsection 4(1) of the Radiocommunication Act.
This equipment complies to RSS-195 in the frequency bands 2305-2320 MHz and 2345-
2360 MHz and RSS-210 Annex 8 in the frequency band 2400-2483.5 MHz.
This device complies with Industry Canada license-exempt RSS standard(s). Operation
is subject to the following two conditions:
This device may not cause interference, and
1.
This device must accept any interference, including interference that may cause
2.
undesired operation of the device.
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropic radiated power (EIRP) is not more than
that required for successful communication.
70-00158-03-00
USER MANUAL
Deployment
PMP
PMP
Proprietary Redline Communications © 2015
Separation Distance
85 cm (33.5") or more
23 cm (9") or more
Page 184 of 254 April 17, 2015